Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 70 and others rescued
#1

Recently acquired this beauty from an auction with several radios that survived a fire.
Upon wipedown and cleaning lightly with Murphy's, this beauty looks pretty good.
Upon close inspection of the cabinet, there are definitely some battle scars.
The chassis looks to be pretty original with the exception of later 40s/50s  electrolytics.
I will be digging into this soon.
Also picked up a 60MB, a JR 80, a 37-60 and a 38-40T as well as two Gloritone 26 radios.
Got the Gloritones to work, the 37-60 sounds nice, but lost her face paint in the fire and the 60MB sounds decent also with new electrolytics..
The jr and the 38-40T are going to require a bit of attention.
I got a bit lucky that transformers, speaker coils and antenna coils are good in all these except the 38-40 which suffered a bit of melty from the fire

Fun work ahead for sure.
I will post as issues arise
Icon_smile
Steve


Attached Files Image(s)
   


Messages In This Thread
philco 70 and others rescued - by steve_mahlberg - 11-11-2021, 05:40 PM
RE: philco 70 and others rescued - by radio1 - 11-11-2021, 08:18 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM

[-]
Who's Online
There are currently no members online.

>