Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12, 2025) x

Thread Closed

An Introduction and a Philco 90 issue.
#17

What Morza is pointing out is important. An 80 rectifier is rated for a first filter of 10 uf (MFD). B+ is also usually higher using larger filter caps, which is already a problem because of the higher line voltages of today. Another problem with these old radios is - tube warm-up time. The voltage in the first filter can go way up waiting for the rest of the tubes to begin conducting. This is also a good reason not to test with the speaker's field coil unplugged.

P.S. when you pull out the old caps, don't throw them out. Several of the forum members would appreciate having them.

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
An Introduction and a Philco 90 issue. - by cknob - 11-23-2021, 09:20 PM
RE: An Introduction and a Philco 90 issue. - by Phlogiston - 11-24-2021, 06:49 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
54C Complete Teardown/Rebuild
Hello Roy, here is this one sincerely Richardradiorich — 12:45 AM
54C Complete Teardown/Rebuild
Richard, Had grabbed it already but thank you just the same.  I find myself wanting to find some way to block out the...glyphmon — 12:03 AM
54C Complete Teardown/Rebuild
Hello roy, here is a link to the schematic . Sincerely Richardradiorich — 11:54 PM
54C Complete Teardown/Rebuild
Richard, The Silvertone 2014 also is a transformerless set, so I am incorporating a 1:1 600 ohm audio isolation transfo...glyphmon — 11:37 PM
Preliminary work on wife's Silvertone 2014
Did an alignment today which was interesting.  IF alignment went great, almost all was already spot-on.  Adjusting on th...glyphmon — 11:35 PM
54C Complete Teardown/Rebuild
The main problem with adding a Bluetooth input is that this set lacks a traditional power transformer to isolate it from...radiorich — 11:19 PM
54C Cabinet Refinish
I started stripping this cabinet before it got super chilly out because I knew I wasn't going to be able to work on ...glyphmon — 11:18 PM
54C Complete Teardown/Rebuild
While I'm waiting to wrap up the final steps on my wife's Silvertone 2014, I started disassembly on the next project.  O...glyphmon — 11:07 PM
Preliminary work on wife's Silvertone 2014
Hello roy, that great news glad it worked out for you !! Sincerely Richardradiorich — 10:50 PM
Preliminary work on wife's Silvertone 2014
Safety caps arrived today.  Soldered one in and had a successful first power-up.  No magic smoke escaped and it tunes in...glyphmon — 09:53 PM

[-]
Who's Online
There are currently no members online.

>