[cknob]

Hi Steve...I'm going back over this again and I'm not sure I understood what RodB asked me to do. He said. "Hi Chris - To measure continuity you want to measure zero or low ohms from one point to another. In this case measure from Tab 1 of the resistor to terminal 4 of the power transformer. Same with terminal 12. If you don't get zero, then why not?"

Tab 1 of the resistor to terminal 4 of the power transformer? Does he mean the center tap line 4 and not terminal 4? He uses the same nomenclature referring to terminal 12. Line 12 is another center tap from the transformer and both taps 4 and 12 are normally connected to terminal one of the voltage resistor. I'm confused!