11-27-2021, 09:57 AM
101 ohms is too high and indicates a bad winding. I'm assuming it's the primary as there is no marking on the diagram as to pin numbers. That's the small winding on lower outside of the coil. Rewind with #38ga wire.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
