Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

The Problem with Zenith 5516 Schematics
#1

I posted part 1 on this parts-change problem a while ago:

https://www.russoldradios.com/blog/zenit...16-chassis

Now here is part 2. Of significance is the comparative/corrected schematic and parts list for the later 1k FC. 

These used to frustrate me. There are a lot of them. Early on I just decided to replace what looked like FACTORY parts with the same value even if different from the schematic. Problem arises when you got one that had already befuddled the previous repair guy. The parts could be - anything.... Anyway, this should resolve the differences in the 1K FC and the 2.125k FC units.

Also has a picture of the Zenith 6-SX-127 - - - yeah, look that one up Icon_lol

https://www.russoldradios.com/blog/zenit...-part-deux

Russ

"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/


Messages In This Thread
The Problem with Zenith 5516 Schematics - by Phlogiston - 12-06-2021, 08:26 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>