Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Hammarlund HQ-129-X
#11

Heard from Mark today and he's making my volume control, went to his site, and completed the order and paid him. I can hardly wait until it arrives. In other news I replaced the power cord last night, but I am waiting until the safety condensers I ordered arrive to hook it in, and also for the volume control with switch to connect the other side, since that is where it goes. So, now I just have to be patient.


Messages In This Thread
Hammarlund HQ-129-X - by mikethedruid - 12-05-2021, 09:55 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-06-2021, 11:30 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-07-2021, 01:58 AM
RE: Hammarlund HQ-129-X - by Mondial - 12-07-2021, 11:54 AM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-07-2021, 12:19 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-08-2021, 02:32 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-08-2021, 10:54 PM
RE: Hammarlund HQ-129-X - by Arran - 12-09-2021, 08:36 AM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-09-2021, 05:40 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-09-2021, 09:12 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-11-2021, 05:39 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-12-2021, 06:57 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-13-2021, 02:26 PM
RE: Hammarlund HQ-129-X - by Arran - 12-15-2021, 01:32 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-03-2022, 06:58 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-05-2022, 04:59 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-09-2022, 01:13 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-10-2022, 02:48 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-10-2022, 09:02 PM
RE: Hammarlund HQ-129-X - by Joe Rossi - 02-10-2022, 10:48 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-10-2022, 11:57 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-11-2022, 11:42 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-12-2022, 11:54 AM
RE: Hammarlund HQ-129-X - by David - 02-12-2022, 05:52 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-13-2022, 01:49 AM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-14-2022, 10:17 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 05-01-2022, 06:34 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 05-02-2022, 10:18 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 05-05-2022, 08:24 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 07-22-2022, 06:17 PM
RE: Hammarlund HQ-129-X - by morzh - 07-22-2022, 06:53 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 07-22-2022, 07:22 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 10-07-2022, 07:44 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 10-09-2022, 09:53 PM
RE: Hammarlund HQ-129-X - by MrFixr55 - 10-10-2022, 06:38 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 2837 online users. [Complete List]
» 2 Member(s) | 2835 Guest(s)
AvatarAvatar

>