[texan george]

Thanks yall,
The voltages on the 26 tubes pin 2 to chassis were: 1st 32V, 2nd 66V, 3rd 28V, and 1st AF 66V. I do get a buzz on pin 3 of the 27. Went back and measured voltages on filter caps to 6 (gnd) and they were #1 170 V, #2 148V, #3 67V, #4 29V, #5 26V.
One other thing is the resistance on the primary of 2nd RF coil I rewound was 5 ohms, checked the other two coils and it measured 20-30 Meg ohms. The BC resistor was open so I installed 2 watt resistors on it, checked them again and they were ok. I'm trying to give you all the info I can and I appreciate everything yall do. Also the 100 ohm resistors on the coils read 108 to 111 ohms so I think they are ok. I think I am at the point where I cant see the forest from the trees.
Thanks,
George