1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 38-12
Radioroslyn
Phorum Expert
*****
Posts: 7,288
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#7

05-03-2011, 06:24 AM
Glad you got your red wire issue figured out. As for the osc coil you will have to relie on the info that came with it to hook it up properly. If you can post a pic of the paper that came with it I'll see what I can do to get it working for you.
Terry
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 38-12 - by radiola - 05-02-2011, 08:07 PM
Re: Philco 38-12 - by 7estatdef - 05-02-2011, 09:16 PM
Re: Philco 38-12 - by radiola - 05-02-2011, 10:19 PM
Re: Philco 38-12 - by 7estatdef - 05-02-2011, 11:20 PM
Re: Philco 38-12 - by radiola - 05-02-2011, 11:32 PM
Re: Philco 38-12 - by radiola - 05-03-2011, 01:33 AM
Re: Philco 38-12 - by 7estatdef - 05-03-2011, 06:24 AM
Re: Philco 38-12 - by radiola - 05-03-2011, 09:57 AM
Re: Philco 38-12 - by 7estatdef - 05-03-2011, 06:32 PM
Re: Philco 38-12 - by radiola - 05-03-2011, 08:58 PM
Re: Philco 38-12 - by 7estatdef - 05-03-2011, 09:48 PM
Re: Philco 38-12 - by radiola - 05-06-2011, 02:42 AM
Re: Philco 38-12 - by 7estatdef - 05-06-2011, 09:53 AM
Re: Philco 38-12 - by radiola - 05-06-2011, 06:02 PM
Re: Philco 38-12 - by 7estatdef - 05-06-2011, 07:43 PM
Re: Philco 38-12 - by radiola - 05-06-2011, 10:45 PM
Re: Philco 38-12 - by radiola - 05-07-2011, 04:04 PM
Re: Philco 38-12 - by 7estatdef - 05-07-2011, 04:21 PM
Re: Philco 38-12 - by radiola - 05-09-2011, 09:46 PM
Re: Philco 38-12 - by radiola - 05-15-2011, 05:27 PM
Re: Philco 38-12 - by radiola - 05-18-2011, 07:21 PM
Re: Philco 38-12 - by 7estatdef - 05-18-2011, 08:04 PM
Re: Philco 38-12 - by radiola - 05-18-2011, 10:11 PM
Re: Philco 38-12 - by 7estatdef - 05-18-2011, 10:54 PM
Re: Philco 38-12 - by radiola - 05-19-2011, 10:45 PM
Re: Philco 38-12 - by 7estatdef - 05-20-2011, 08:56 AM
Re: Philco 38-12 - by radiola - 05-20-2011, 05:26 PM
Re: Philco 38-12 - by 7estatdef - 05-20-2011, 08:04 PM
Re: Philco 38-12 - by radiola - 05-20-2011, 09:20 PM
Re: Philco 38-12 - by 7estatdef - 05-20-2011, 10:10 PM
Re: Philco 38-12 - by radiola - 05-21-2011, 11:23 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM
38-10T chassis Restoration begins
I have a question about the mica sheets. I thought I saw somewhere on the Phorum where someone used thin plastic report ...dconant — 10:44 AM
38-10T chassis Restoration begins
Yes, you should carefully remove the mica sheets from the trimmers otherwise you risk trapping foreign material in the t...RodB — 10:34 AM

[-]
Who's Online
There are currently 2739 online users. [Complete List]
» 1 Member(s) | 2738 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration