1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Westinghouse H-104A - Low Volume
Masonparker
Junior Member
**
Posts: 47
Threads: 10
Joined: Nov 2020
City: CHESAPEAKE State, Province, Country: VA
#3

01-02-2022, 05:17 PM
I added the schematic that has the updated circuity for the 6AT6

The 470K (#43)  resistor is good and the 680K (#45) resistor is good

I checked the resistance of 6AT6 per the last attached supplement  ( used two different tubes)
The resistance at Pin 7 was way off. ( see page 2 of the attachement)

The voltage across the 470K is 4.1 volts  the 680K is 3.8


Attached Files
.pdf Scan_0062.pdf Size: 715.27 KB  Downloads: 135
Find
« Next Oldest | Next Newest »


Messages In This Thread
Westinghouse H-104A - Low Volume - by Masonparker - 01-02-2022, 12:17 PM
RE: Westinghouse H-104A - Low Volume - by Mondial - 01-02-2022, 01:13 PM
RE: Westinghouse H-104A - Low Volume - by Masonparker - 01-02-2022, 05:17 PM
RE: Westinghouse H-104A - Low Volume - by Mondial - 01-02-2022, 07:33 PM
RE: Westinghouse H-104A - Low Volume - by Mondial - 01-03-2022, 09:54 PM
RE: Westinghouse H-104A - Low Volume - by Mondial - 01-04-2022, 10:52 PM
RE: Westinghouse H-104A - Low Volume - by David - 01-08-2022, 04:40 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM
Philco 60 Squealing
I just peaked it for the best signal at 600. NULL it for IF frequency, originally it would have been null for 500kh...Chas — 08:05 PM
Philco 60 Squealing
Wavetrap no longer matters.morzh — 05:19 PM
Philco 60 Squealing
Rod, I had checked out your suggestions but did not help. I did solder the ground rivets to the chassis as Chas suggeste...dconant — 04:52 PM
37-690 Bass Choke Replacement
Yeah, I know, Mouser and Digikey don't have "big iron" components. For some reason Philco was messing with the...Radiodial — 04:25 PM
37-690 Bass Choke Replacement
Yes, I just had to deal with that while repairing the 37-604 Philco. Exactly that value choke was gone. And the current ...morzh — 03:52 PM
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM

[-]
Who's Online
There are currently 3780 online users. [Complete List]
» 1 Member(s) | 3779 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)