Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Stromberg-Carlson 320-T
#30

Yes our dining room table has feet very similar to this. I've played with CAD and tried to sort out how to design the bezel but I think I'll go with wood.


Messages In This Thread
Stromberg-Carlson 320-T - by klondike98 - 04-15-2021, 10:19 PM
RE: Stromberg-Carlson 320-T - by radiorich - 04-15-2021, 11:22 PM
RE: Stromberg-Carlson 320-T - by OZ4 - 04-16-2021, 10:34 AM
RE: Stromberg-Carlson 320-T - by Chas - 04-16-2021, 12:07 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 04-16-2021, 12:54 PM
RE: Stromberg-Carlson 320-T - by mikethedruid - 04-16-2021, 01:33 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 04-16-2021, 01:55 PM
RE: Stromberg-Carlson 320-T - by Arran - 04-16-2021, 09:27 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 04-16-2021, 09:49 PM
RE: Stromberg-Carlson 320-T - by Arran - 04-17-2021, 01:55 AM
RE: Stromberg-Carlson 320-T - by klondike98 - 04-17-2021, 02:37 AM
RE: Stromberg-Carlson 320-T - by klondike98 - 04-22-2021, 04:34 PM
RE: Stromberg-Carlson 320-T - by Eliot Ness - 04-23-2021, 02:56 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 04-25-2021, 08:13 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 05-02-2021, 11:07 PM
RE: Stromberg-Carlson 320-T - by Eliot Ness - 05-03-2021, 10:32 AM
RE: Stromberg-Carlson 320-T - by morzh - 05-03-2021, 10:39 AM
RE: Stromberg-Carlson 320-T - by klondike98 - 05-03-2021, 09:35 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 05-04-2021, 11:58 PM
RE: Stromberg-Carlson 320-T - by RodB - 05-05-2021, 09:30 AM
RE: Stromberg-Carlson 320-T - by morzh - 05-05-2021, 09:32 AM
RE: Stromberg-Carlson 320-T - by Eliot Ness - 05-05-2021, 10:59 AM
RE: Stromberg-Carlson 320-T - by klondike98 - 05-05-2021, 01:23 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 12-31-2021, 10:25 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 01-04-2022, 10:06 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 01-17-2022, 12:55 PM
RE: Stromberg-Carlson 320-T - by Brad Winder - 01-18-2022, 12:51 PM
RE: Stromberg-Carlson 320-T - by Eliot Ness - 01-18-2022, 02:11 PM
RE: Stromberg-Carlson 320-T - by Paul Philco322 - 01-18-2022, 03:32 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 01-19-2022, 05:26 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 01-21-2022, 01:08 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 01-30-2022, 02:24 PM
RE: Stromberg-Carlson 320-T - by Paul Philco322 - 01-30-2022, 02:26 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 05-30-2022, 09:41 PM
RE: Stromberg-Carlson 320-T - by klondike98 - 01-11-2023, 03:49 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 5538 online users. [Complete List]
» 2 Member(s) | 5536 Guest(s)
AvatarAvatar

>