Advice needed on hot air rework station

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Advice needed on hot air rework station

RodB
Phorum Expert

Posts: 986
Threads: 40
Joined: Feb 2015
City: Roseville, MN

02-18-2022, 11:01 AM

I worked with an AOYUE for over 6 years and it seemed to have had everything we needed. Has a lot of accessories. Nowadays they even have a vacuum pump for quickly removing solder. I think you can get a good one for $150-$200.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Advice needed on hot air rework station - by radiorich - 02-17-2022, 01:49 AM

RE: Advice needed on hot air rework station - by Ron Ramirez - 02-18-2022, 09:42 AM

RE: Advice needed on hot air rework station - by radiorich - 02-18-2022, 10:20 AM

RE: Advice needed on hot air rework station - by RodB - 02-18-2022, 11:01 AM

RE: Advice needed on hot air rework station - by radiorich - 05-10-2023, 10:10 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the 5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM

Who's Online

There are currently 2827 online users. [Complete List]
» 1 Member(s) | 2826 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me