1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 16B
GarySP
Super Moderator
******
Posts: 2,135
Threads: 158
Joined: Jan 2013
City: Westland, MI
#5

02-26-2022, 01:19 PM
+1 what Steve mentioned about the resistor wire. If it ohms out close enough reuse it. One I rebuilt had fish paper wrapped around it, then stuffed into the bakelight casing. In my case it was looking less than reliable, so I replaced it with a 250 ohm 1 watt resistor. (probably could have used a 1/2 watt) Take care and BE HEALTHY! Gary
"Don't pity the dead, pity the living, above all, those living without love."
Professor Albus Dumbledore
Gary - Westland Michigan
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 16B - by vecher - 02-25-2022, 07:35 PM
RE: Philco 16B - by Kestas - 02-25-2022, 10:03 PM
RE: Philco 16B - by RodB - 02-26-2022, 09:40 AM
RE: Philco 16B - by Steve Davis - 02-26-2022, 10:53 AM
RE: Philco 16B - by GarySP - 02-26-2022, 01:19 PM
RE: Philco 16B - by vecher - 03-12-2022, 09:20 PM
RE: Philco 16B - by radiorich - 03-12-2022, 09:30 PM
RE: Philco 16B - by mikethedruid - 03-13-2022, 12:07 AM
RE: Philco 16B - by vecher - 03-15-2022, 10:17 AM
RE: Philco 16B - by Mondial - 03-15-2022, 01:14 PM
RE: Philco 16B - by Kestas - 03-15-2022, 02:04 PM
RE: Philco 16B - by mikethedruid - 03-15-2022, 02:12 PM
RE: Philco 16B - by radiorich - 03-15-2022, 02:58 PM
RE: Philco 16B - by vecher - 04-05-2022, 10:18 AM
RE: Philco 16B - by Radioroslyn - 06-02-2022, 09:15 AM
RE: Philco 16B - by Tim Tress - 06-03-2022, 09:11 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Hi Paulo, Welcome to the Philco Phorum. I can see why you want to find good reproduction parts. That is a bea...MrFixr55 — 11:10 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM

[-]
Who's Online
There are currently 1456 online users. [Complete List]
» 2 Member(s) | 1454 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration