Posts: 23
Threads: 1
Joined: Mar 2022
City: Russellville
State, Province, Country: Ohio
Hello. So I am back at the 610 this week. I was out of town last week so I didn't have much to report. The one thing that I have managed to figure out is that my radio is a version that is wired like the newer drawing that is available but does not include the phonograph. Also my version does not include one of the bakalite block capacitor but has two of these(see photo) instead.There are other minor changes that were confusing me that I was able to figure out. One thing I learned pretty fast from reading other posts on this sight was to get the tube pin out and mark it on large blown up drawing. Once I did this I was able to trace all the wiring and get a better understanding of what I got. I also got all my new capacitors and resistors to get started on replacing them. Is it possible to clean the tuning capacitor without removing it from the chassis? I think that might be my worse job ahead of me
as I have already cleaned out the bakalite blocks.. Thanks for the interest in my progress. Jim B.
Messages In This Thread
RE: Philco 610 - by JimB - 03-23-2022, 07:12 AM
Users browsing this thread: 2 Guest(s)
|
Recent Posts
|
Bakelite crack repair - what is best epoxy?
|
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM |
Jackson 665 j2 schematic request
|
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM |
Jackson 665 j2 schematic request
|
Looking for a schematic for the 665 j2 multimeter.daveone23 — 04:42 PM |
Looking for place to donate unique Philco Philco J-1930 Prototype
|
>>I'll write to the Henry Ford.
I heard, his secretary answers his mail, not he himself.morzh — 12:15 PM |
Philco 48-200 alignment questions
|
Just checked the power cord and I did in fact wire it so the hot side (small prong) goes to the switch.transitony — 11:52 AM |
Looking for place to donate unique Philco Philco J-1930 Prototype
|
Thanks for the suggestions. I'll write to the Henry Ford. That would certainly make sense since by the time this prod...jeibner — 11:49 AM |
Looking for place to donate unique Philco Philco J-1930 Prototype
|
For what it's worth, the Henry Ford Museum and Greenfield Village in Dearborn, Michigan may be an option.
The obvious ...GarySP — 11:39 AM |
Help with Readrite 410 tube tester
|
Mike and I just had a short discussion yesterday about this very subject. So often it's the connections. Ya gotta have t...RodB — 10:08 AM |
Looking for place to donate unique Philco Philco J-1930 Prototype
|
We have a regional museum here in the Twin Cities called The Pavek Museum. They have an extensive collection of communic...RodB — 09:30 AM |
Philco 89B code 123 newbie
|
I did some nosing around and found that the original caps were 4 3/4" long x 1 5/16" in dia. Guess what 1"...Radioroslyn — 09:28 AM |
Who's Online
|
There are currently 4906 online users. [Complete List] » 2 Member(s) | 4904 Guest(s)
|
|
|
|