Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 86
#10

Fortunately the late 1929-30 Philco lowboy cabinets were sold with a multitude of chassis, so they built a lot of them. It might be an idea to post an ad looking for the legs, and posts from a junk cabinet, I remember Rodney out in Washington found one that had been stored outside under some stairs, but salvaged the chassis, and some solid wood cabinet parts, there may be others out there. Actually the cabinet you have is different from the one Rodney had, so I think it may be a 1928 model console.
Regards
Arran


Messages In This Thread
Philco 86 - by texan george - 02-24-2022, 12:44 PM
RE: Philco 86 - by klondike98 - 02-26-2022, 02:14 PM
RE: Philco 86 - by GarySP - 02-26-2022, 05:30 PM
RE: Philco 86 - by texan george - 02-27-2022, 11:43 AM
RE: Philco 86 - by GarySP - 02-27-2022, 12:25 PM
RE: Philco 86 - by texan george - 02-28-2022, 02:22 PM
RE: Philco 86 - by texan george - 03-16-2022, 02:51 PM
RE: Philco 86 - by John Bartley - 03-16-2022, 03:05 PM
RE: Philco 86 - by texan george - 03-16-2022, 06:07 PM
RE: Philco 86 - by Arran - 03-23-2022, 08:42 AM
RE: Philco 86 - by texan george - 03-23-2022, 03:07 PM
RE: Philco 86 - by John Bartley - 03-23-2022, 03:34 PM
RE: Philco 86 - by texan george - 03-24-2022, 01:33 PM
RE: Philco 86 - by texan george - 03-29-2022, 03:53 PM
RE: Philco 86 - by GarySP - 03-30-2022, 05:25 PM
RE: Philco 86 - by texan george - 03-31-2022, 08:51 AM
RE: Philco 86 - by texan george - 03-31-2022, 01:53 PM
RE: Philco 86 - by RodB - 03-31-2022, 04:40 PM
RE: Philco 86 - by Ron Ramirez - 03-31-2022, 10:42 PM
RE: Philco 86 - by radiorich - 04-01-2022, 12:57 AM
RE: Philco 86 - by texan george - 04-01-2022, 08:59 AM
RE: Philco 86 - by Ron Ramirez - 04-01-2022, 09:10 AM
RE: Philco 86 - by texan george - 04-01-2022, 02:19 PM
RE: Philco 86 - by texan george - 04-02-2022, 07:51 AM
RE: Philco 86 - by texan george - 04-03-2022, 03:40 PM
RE: Philco 86 - by Simon Wa3uay - 04-05-2022, 08:14 AM
RE: Philco 86 - by GarySP - 04-05-2022, 08:26 AM
RE: Philco 86 - by texan george - 04-05-2022, 11:08 AM
RE: Philco 86 - by texan george - 04-11-2022, 02:55 PM
RE: Philco 86 - by klondike98 - 04-12-2022, 05:23 PM
RE: Philco 86 - by texan george - 04-13-2022, 01:28 PM
RE: Philco 86 - by texan george - 04-16-2022, 11:21 AM
RE: Philco 86 - by Ron Ramirez - 04-16-2022, 11:30 AM
RE: Philco 86 - by radiorich - 04-16-2022, 01:03 PM
RE: Philco 86 - by texan george - 04-16-2022, 01:43 PM
RE: Philco 86 - by John Bartley - 04-16-2022, 02:21 PM
RE: Philco 86 - by GarySP - 04-16-2022, 09:33 PM



Users browsing this thread: 11 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6782 online users. [Complete List]
» 1 Member(s) | 6781 Guest(s)
Avatar

>