1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Enameled Wire?
mikethedruid
Banned
Posts: 1,824
Threads: 114
Joined: Jul 2014
City: Sneedville, TN
#7

03-27-2022, 02:50 PM
I have only seen this use of the secondary enameled wire to connect with the voice coil wiring in cases where the output transformer was either mounted directly on the frame of the speaker, or VERY close by, and in any case where there might be a problem with rubbing and shorting a piece of "spaghetti" was used over the wire to prevent that.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Enameled Wire? - by Paul Philco322 - 03-26-2022, 08:10 PM
RE: Enameled Wire? - by morzh - 03-26-2022, 09:10 PM
RE: Enameled Wire? - by mikethedruid - 03-27-2022, 12:24 AM
RE: Enameled Wire? - by Paul Philco322 - 03-27-2022, 08:26 AM
RE: Enameled Wire? - by Ron Ramirez - 03-27-2022, 09:30 AM
RE: Enameled Wire? - by Mondial - 03-27-2022, 11:41 AM
RE: Enameled Wire? - by mikethedruid - 03-27-2022, 02:50 PM
RE: Enameled Wire? - by Ron Ramirez - 03-27-2022, 03:06 PM
RE: Enameled Wire? - by Paul Philco322 - 03-27-2022, 07:41 PM
RE: Enameled Wire? - by Ron Ramirez - 03-27-2022, 07:53 PM
RE: Enameled Wire? - by Paul Philco322 - 03-27-2022, 08:02 PM
RE: Enameled Wire? - by Paul Philco322 - 04-01-2022, 07:59 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 7533 online users. [Complete List]
» 1 Member(s) | 7532 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)