Maybe I should get a spare wire wound resistor to have as a backup since mine is looking bad. Saw one for sale on eBay that looks nice. But hey it’s testing perfect though!
The voltage on those caps is 450, so it’s good there. I’m just going to put the same value replacements in there for now since I know they work. Plus it comes out to 8 anyway. I thought it doubled if they are in series, but it makes sense now! Once I get the oscillator coil rewound and back up and running, I’ll do some voltage checks on the tube pins.
Messages In This Thread
Philco 60 - by brandonkr1 - 04-07-2022, 06:42 PM
RE: 3 filter caps??? Model 60 - by brandonkr1 - 04-10-2022, 07:30 PM
Users browsing this thread: 1 Guest(s)
|
Recent Posts
|
Philco 46-420 Code 121 Reception issues
|
Welcome Eric,
I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM |
Philco 46-420 Code 121 Reception issues
|
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM |
Philco 42-1008 conversion kit
|
Interesting. I haven't seen that before.klondike98 — 07:02 PM |
12' Philco
|
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM |
Shadow Meter Bulb
|
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM |
Shadow Meter Bulb
|
Ok. Thanks for the correction.RossH — 03:09 PM |
Model 28L
|
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM |
37-60 revision 6
|
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM |
Shadow Meter Bulb
|
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM |
Hickok AC51 tube tester
|
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM |
Who's Online
|
There are currently no members online. |
|
|