Posts: 23
Threads: 1
Joined: Mar 2022
City: Russellville
State, Province, Country: Ohio
I did check the oscillator frequencies with an other radio. The dial on the tuning cap is installed by the use of a set screw on the shaft of the tuning cap. To install it I tuned to a known station and tightened it on that setting. I don't have a frequency generator to align it. Without some more equipment I think I am out of luck. I guess I'm luck it pays as good as it does.
Messages In This Thread
RE: Philco 610 - by JimB - 04-19-2022, 06:15 PM
Users browsing this thread: 3 Guest(s)
|
Recent Posts
|
trying to identify this wire type
|
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM |
trying to identify this wire type
|
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM |
Gilfillan Brothers Car Radio?
|
Hi everyone,
Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM |
trying to identify this wire type
|
Here's one source for your wire of many.
Take care and BE HEALTHY! Gary
P.S. Can't get the right color you need? I ...GarySP — 06:40 PM |
trying to identify this wire type
|
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM |
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
|
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM |
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
|
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM |
trying to identify this wire type
|
The red wire is rubber covered wire.
The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM |
trying to identify this wire type
|
Greetings Phorum members,
Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM |
Philco 60 Squealing
|
All correct shields must be in place, all tubes correct no subs of any kind.
Check any soldered, riveted ground conne...Chas — 01:24 PM |
Who's Online
|
There are currently 7140 online users. [Complete List] » 1 Member(s) | 7139 Guest(s)
|
|
|
|