1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-12 Oscillator Replacement
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#13

04-29-2022, 05:17 PM
Check #11 for proper value and replace 5 and 6 (grid leak) resistor and cap. Should have hv on grids 2,3, and 5 on the 6A7. And hv on the plate.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
38-12 Oscillator Replacement - by Radioguy52 - 04-28-2022, 12:17 PM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 04-28-2022, 03:41 PM
RE: 38-12 Oscillator Replacement - by Radioroslyn - 04-28-2022, 05:40 PM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 04-28-2022, 06:11 PM
RE: 38-12 Oscillator Replacement - by Radioroslyn - 04-28-2022, 06:48 PM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 04-28-2022, 10:19 PM
RE: 38-12 Oscillator Replacement - by Chas - 04-28-2022, 11:14 PM
RE: 38-12 Oscillator Replacement - by Radioroslyn - 04-29-2022, 10:53 AM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 04-29-2022, 11:49 AM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 04-29-2022, 11:52 AM
RE: 38-12 Oscillator Replacement - by Radioroslyn - 04-29-2022, 03:54 PM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 04-29-2022, 04:46 PM
RE: 38-12 Oscillator Replacement - by Radioroslyn - 04-29-2022, 05:17 PM
RE: 38-12 Oscillator Replacement - by Radioroslyn - 04-29-2022, 05:28 PM
RE: 38-12 Oscillator Replacement - by BrendaAnnD - 04-30-2022, 03:11 AM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 05-01-2022, 07:21 PM
RE: 38-12 Oscillator Replacement - by Mondial - 05-01-2022, 09:29 PM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 05-01-2022, 11:02 PM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 05-10-2022, 09:09 AM
RE: 38-12 Oscillator Replacement - by Chas - 05-10-2022, 10:42 AM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 05-10-2022, 11:14 AM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 05-10-2022, 12:07 PM
RE: 38-12 Oscillator Replacement - by David - 05-10-2022, 12:59 PM
RE: 38-12 Oscillator Replacement - by Radioguy52 - 05-10-2022, 03:38 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration