Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Hammarlund HQ-129-X
#28

Past two nights I have been carefully realigning the radio, first with my signal generator, double checking the frequency with the PL-600, then doing final tweaking with live known stations to get the best reception. With everything done I would rate this receiver a little above my National NC-125 and my Lafayette HE=30, about on par with my Scott SLRM, and almost as good as my Hammarlund HQ-140-X


Messages In This Thread
Hammarlund HQ-129-X - by mikethedruid - 12-05-2021, 08:55 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-06-2021, 10:30 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-07-2021, 12:58 AM
RE: Hammarlund HQ-129-X - by Mondial - 12-07-2021, 10:54 AM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-07-2021, 11:19 AM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-08-2021, 01:32 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-08-2021, 09:54 PM
RE: Hammarlund HQ-129-X - by Arran - 12-09-2021, 07:36 AM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-09-2021, 04:40 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-09-2021, 08:12 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-11-2021, 04:39 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-12-2021, 05:57 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 12-13-2021, 01:26 PM
RE: Hammarlund HQ-129-X - by Arran - 12-15-2021, 12:32 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-03-2022, 05:58 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-05-2022, 03:59 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-09-2022, 12:13 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-10-2022, 01:48 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-10-2022, 08:02 PM
RE: Hammarlund HQ-129-X - by Joe Rossi - 02-10-2022, 09:48 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-10-2022, 10:57 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-11-2022, 10:42 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-12-2022, 10:54 AM
RE: Hammarlund HQ-129-X - by David - 02-12-2022, 04:52 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-13-2022, 12:49 AM
RE: Hammarlund HQ-129-X - by mikethedruid - 02-14-2022, 09:17 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 05-01-2022, 05:34 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 05-02-2022, 09:18 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 05-05-2022, 07:24 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 07-22-2022, 05:17 PM
RE: Hammarlund HQ-129-X - by morzh - 07-22-2022, 05:53 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 07-22-2022, 06:22 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 10-07-2022, 06:44 PM
RE: Hammarlund HQ-129-X - by mikethedruid - 10-09-2022, 08:53 PM
RE: Hammarlund HQ-129-X - by MrFixr55 - 10-10-2022, 05:38 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently no members online.

>