Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Mystery Control
#2

I found that the domed center section of the dial un-screws - counterclockwise. Beneath there are 3 brass screws. this is as far as I have gotten, but I think that the dial stop should be removed first, it is secured from the bottom. My dial is so warped that it appears to be stuck and I have not gone any further until I can spend some '"quality time" in performing this operation. Good luck with yours.


Messages In This Thread
Mystery Control - by gregb - 05-11-2022, 05:18 PM
RE: Mystery Control - by patrician56 - 05-12-2022, 08:40 AM
RE: Mystery Control - by gregb - 05-12-2022, 08:53 AM
RE: Mystery Control - by BrendaAnnD - 05-12-2022, 02:09 PM
RE: Mystery Control - by Ron Ramirez - 05-12-2022, 03:09 PM
RE: Mystery Control - by gregb - 05-12-2022, 03:26 PM
RE: Mystery Control - by gregb - 05-12-2022, 03:26 PM
RE: Mystery Control - by gregb - 05-12-2022, 04:31 PM
RE: Mystery Control - by gregb - 05-12-2022, 04:56 PM
RE: Mystery Control - by Brad Winder - 05-14-2022, 05:14 AM
RE: Mystery Control - by gregb - 05-14-2022, 11:08 AM
RE: Mystery Control - by Brad Winder - 05-14-2022, 11:25 AM
RE: Mystery Control - by GarySP - 05-14-2022, 01:17 PM
RE: Mystery Control - by gregb - 05-15-2022, 05:58 PM
RE: Mystery Control - by Arran - 05-15-2022, 08:23 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2940 online users. [Complete List]
» 1 Member(s) | 2939 Guest(s)
Avatar

>