Westinghouse N-202

Thread Rating:

1 Vote(s) - 2 Average
1
2
3
4
5

Linear Mode

Westinghouse N-202

klondike98
Phorum Moderator

Posts: 5,088
Threads: 270
Joined: Nov 2012
City: Wilsonville State, Province, Country: OR

#23

05-23-2022, 11:06 PM

Yes the 480 ohm is consistent during full rotation of the rotor. I think I’ll pull the tuning cap out for a better look at it and cleaning. I should have checked for shorts etc when I had it out before Icon_exclaim

Thanks Mr. F.

Cheers,
Bob
[Image: https://www.dropbox.com/s/5m63ib99yfx2eg....jpg?raw=1]
Bob's Restorations Web Page

Website Find

« Next Oldest | Next Newest »

Messages In This Thread

Westinghouse N-202 - by klondike98 - 03-29-2022, 08:11 PM

RE: Westinghouse N-202 - by captainclock1988 - 03-30-2022, 10:37 AM

RE: Westinghouse N-202 - by klondike98 - 03-30-2022, 04:42 PM

RE: Westinghouse N-202 - by GarySP - 03-30-2022, 05:01 PM

RE: Westinghouse N-202 - by klondike98 - 04-03-2022, 10:14 PM

RE: Westinghouse N-202 - by klondike98 - 05-06-2022, 09:54 PM

RE: Westinghouse N-202 - by Mondial - 05-06-2022, 10:31 PM

RE: Westinghouse N-202 - by captainclock1988 - 05-07-2022, 03:01 AM

RE: Westinghouse N-202 - by RodB - 05-07-2022, 08:44 AM

RE: Westinghouse N-202 - by klondike98 - 05-07-2022, 11:57 AM

RE: Westinghouse N-202 - by RodB - 05-07-2022, 01:35 PM

RE: Westinghouse N-202 - by klondike98 - 05-07-2022, 10:11 PM

RE: Westinghouse N-202 - by klondike98 - 05-14-2022, 09:29 PM

RE: Westinghouse N-202 - by RodB - 05-14-2022, 10:28 PM

RE: Westinghouse N-202 - by Chas - 05-15-2022, 10:01 AM

RE: Westinghouse N-202 - by klondike98 - 05-15-2022, 04:36 PM

RE: Westinghouse N-202 - by GarySP - 05-15-2022, 05:45 PM

RE: Westinghouse N-202 - by klondike98 - 05-15-2022, 07:00 PM

RE: Westinghouse N-202 - by Arran - 05-15-2022, 09:29 PM

RE: Westinghouse N-202 - by klondike98 - 05-16-2022, 12:54 PM

RE: Westinghouse N-202 - by klondike98 - 05-23-2022, 07:47 PM

RE: Westinghouse N-202 - by MrFixr55 - 05-23-2022, 09:17 PM

RE: Westinghouse N-202 - by klondike98 - 05-23-2022, 11:06 PM

RE: Westinghouse N-202 - by klondike98 - 05-25-2022, 09:22 PM

RE: Westinghouse N-202 - by GarySP - 05-25-2022, 10:06 PM

RE: Westinghouse N-202 - by radiorich - 05-25-2022, 11:50 PM

RE: Westinghouse N-202 - by klondike98 - 05-30-2022, 10:03 PM

RE: Westinghouse N-202 - by MrFixr55 - 05-31-2022, 07:18 AM

RE: Westinghouse N-202 - by klondike98 - 06-02-2022, 09:47 PM

RE: Westinghouse N-202 - by GarySP - 06-03-2022, 09:13 AM

RE: Westinghouse N-202 - by Paul Philco322 - 06-03-2022, 04:36 PM

RE: Westinghouse N-202 - by klondike98 - 06-13-2022, 10:43 PM

RE: Westinghouse N-202 - by MrFixr55 - 06-13-2022, 11:25 PM

RE: Westinghouse N-202 - by klondike98 - 06-15-2022, 07:03 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

Who's Online

There are currently 4230 online users. [Complete List]
» 3 Member(s) | 4227 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me