49-1401 no audio

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

49-1401 no audio

Cu879
Junior Member

Posts: 14
Threads: 5
Joined: Mar 2021
City: Bakersfield State, Province, Country: Ca

#13

06-04-2022, 12:56 AM

Hello all. Sorry for the delay. I finally got back to it. I’m not any closer to getting it working. It was mentioned that maybe there is power supply issue. I schematic has a fairly good troubleshooting guide, so I went back to the power section. Both test points A and C have voltages close to 190 volts. C should be 200 volts, but the A point should be 110. Unfortunately, there is no troubleshooting for high voltage. The 2 resistors test in spec. The 50y6 and 35l6 both get very hot quickly, due to the over voltage. The 6AQ6 is cold. The B- between the 6AQ6 and 12BE6 is good.

I’m being to think this is above my pay grade and it is time to move onto the next project.

Find

« Next Oldest | Next Newest »

Messages In This Thread

49-1401 no audio - by Cu879 - 05-07-2022, 09:47 PM

RE: 49-1401 no audio - by Mondial - 05-07-2022, 11:48 PM

RE: 49-1401 no audio - by Cu879 - 05-08-2022, 12:05 PM

RE: 49-1401 no audio - by Mondial - 05-08-2022, 04:17 PM

RE: 49-1401 no audio - by RodB - 05-08-2022, 05:19 PM

RE: 49-1401 no audio - by Radioroslyn - 05-08-2022, 11:31 PM

RE: 49-1401 no audio - by Mondial - 05-09-2022, 12:03 AM

RE: 49-1401 no audio - by BrendaAnnD - 05-09-2022, 07:54 AM

RE: 49-1401 no audio - by BrendaAnnD - 05-09-2022, 09:54 AM

RE: 49-1401 no audio - by BrendaAnnD - 05-09-2022, 10:01 AM

RE: 49-1401 no audio - by Cu879 - 05-09-2022, 04:51 PM

RE: 49-1401 no audio - by MrFixr55 - 05-09-2022, 10:01 PM

RE: 49-1401 no audio - by Cu879 - 06-04-2022, 12:56 AM

RE: 49-1401 no audio - by RodB - 06-04-2022, 08:26 AM

Jmay - by Jmay - 06-04-2022, 04:23 PM

RE: 49-1401 no audio - by Radioroslyn - 06-04-2022, 05:13 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me