1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Zenith 5-S-119
JimSirt
Member
**
Posts: 21
Threads: 2
Joined: Dec 2021
City: Grafton State, Province, Country: ON
#4

06-22-2022, 12:07 PM
I've been following the one you're referring to on a Canadian Auction site. A bit of a Frankenradio. Too bad that the correct speaker and plug are missing and the hand written band position markings may be difficult to remove. I think this could be a great project but for me, the current high bid is too much for this one.

Jim
Find
« Next Oldest | Next Newest »


Messages In This Thread
Zenith 5-S-119 - by GRG - 06-21-2022, 09:57 AM
RE: Zenith 5-S-119 - by Eliot Ness - 06-21-2022, 12:54 PM
RE: Zenith 5-S-119 - by GRG - 06-21-2022, 05:15 PM
RE: Zenith 5-S-119 - by JimSirt - 06-22-2022, 12:07 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
Is it possible that the 0Z4 is actually a 6Z4/84? Also the tubes that came with the radio may not all be the correct on...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM

[-]
Who's Online
There are currently 1643 online users. [Complete List]
» 3 Member(s) | 1640 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)