1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco-Transitone Auto Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco/Hupmobile Radio
ccwb
New Member
*
Posts: 2
Threads: 1
Joined: May 2011
#1

05-16-2011, 11:15 AM
I have a Philco/Hupmobile radio for my 1934 Model K Hupmobile. I am not sure how to install it. I took off the back plate and it says that the radio in a Superheterodyne Model D. The control is on the steering column marked Philco/Hubmobile. The wires on the radio are not marked so I don't know what goes where. The Hupp has a positive ground.

Would appreciate any help you can give.

Charlie
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco/Hupmobile Radio - by ccwb - 05-16-2011, 11:15 AM
Re: Philco/Hupmobile Radio - by BILL - 05-16-2011, 06:29 PM
Re: Philco/Hupmobile Radio - by ccwb - 05-16-2011, 07:15 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM

[-]
Who's Online
There are currently 3005 online users. [Complete List]
» 1 Member(s) | 3004 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco-Transitone Auto Radios