1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
GE 401 Tube sub question
Paul Philco322
Super Moderator
******
Posts: 4,381
Threads: 412
Joined: Jun 2011
City: Boston State, Province, Country: Massachusetts
#10

08-22-2022, 06:40 PM
Maybe a bad IF trfr. I did my swap, can tune over 850AM, but nothing lower. Had this before and 1 IF was shot, oh well tubecwould have been easy. Paul B.
Tubetalk1
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
GE 401 Tube sub question - by Paul Philco322 - 08-21-2022, 01:05 PM
RE: GE 401 Tube sub question - by RodB - 08-21-2022, 03:43 PM
RE: GE 401 Tube sub question - by Paul Philco322 - 08-21-2022, 05:02 PM
RE: GE 401 Tube sub question - by David - 08-21-2022, 05:48 PM
RE: GE 401 Tube sub question - by MrFixr55 - 08-21-2022, 06:16 PM
RE: GE 401 Tube sub question - by Radioroslyn - 08-21-2022, 08:07 PM
RE: GE 401 Tube sub question - by Paul Philco322 - 08-21-2022, 08:57 PM
RE: GE 401 Tube sub question - by mikethedruid - 08-22-2022, 12:06 AM
RE: GE 401 Tube sub question - by Paul Philco322 - 08-22-2022, 06:28 AM
RE: GE 401 Tube sub question - by Paul Philco322 - 08-22-2022, 06:40 PM
RE: GE 401 Tube sub question - by Paul Philco322 - 08-24-2022, 01:38 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 6249 online users. [Complete List]
» 2 Member(s) | 6247 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)