1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 38-12 oscillator coil
Tubeglow20
Junior Member
**
Posts: 24
Threads: 6
Joined: Jan 2020
City: Laceys Spring State, Province, Country: Alabama
#1

08-26-2022, 02:23 PM
    Hello, I know that the topic of the Philco 38-12 oscillator coil has been discussed many times on the phorum,  but I have a question I wanted to ask before I mess something up. On my oscillator coil, the primary, terminals 1 & 2, show a resistance of 2.9 ohms and the schematic shows 2.5 ohms which I know is close enough. The secondary,  terminals 3 & 4, show 1.5 ohms and the schematic shows 3.5 ohms. The secondary winding looks good for the most part, but there is some green corrosion on the winding. Would this have an effect on the DC resistance and make it drop? Will the coil work as is, or will I need to rewind the secondary?
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 38-12 oscillator coil - by Tubeglow20 - 08-26-2022, 02:23 PM
RE: Philco 38-12 oscillator coil - by Radioroslyn - 08-27-2022, 06:40 PM
RE: Philco 38-12 oscillator coil - by Ron Ramirez - 08-27-2022, 08:13 PM
RE: Philco 38-12 oscillator coil - by Radioroslyn - 08-27-2022, 10:10 PM
RE: Philco 38-12 oscillator coil - by Ron Ramirez - 08-27-2022, 10:45 PM
RE: Philco 38-12 oscillator coil - by Radioroslyn - 08-28-2022, 05:18 AM
RE: Philco 38-12 oscillator coil - by RodB - 08-28-2022, 08:18 AM
RE: Philco 38-12 oscillator coil - by Tubeglow20 - 09-25-2022, 12:50 PM
RE: Philco 38-12 oscillator coil - by morzh - 09-25-2022, 07:43 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 7023 online users. [Complete List]
» 2 Member(s) | 7021 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration