1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Refinishing Bezel
Sean
Member
***
Posts: 151
Threads: 5
Joined: Oct 2005
City: Sullivan, MO
#3

09-14-2022, 09:00 AM
You might look into a self-adhesive vinyl with a wood grain on it.  I had bought some a few years ago from a company who markets it for putting wood grain on vehicle dashboards.  It can be worked around curves like those on your bezel.  I've used it on a couple radio projects.  One was to replace a photo finish burl walnut strip on an Airline cabinet and the other to cover the face plate on an Atwater Kent 480.

I believe I bought it from Metro Restyling:

https://metrorestyling.com/collections/w...vinyl-wrap
Sean
WØKPX
Find
« Next Oldest | Next Newest »


Messages In This Thread
Refinishing Bezel - by Pcorb - 09-13-2022, 03:46 PM
RE: Refinishing Bezel - by klondike98 - 09-13-2022, 04:21 PM
RE: Refinishing Bezel - by Sean - 09-14-2022, 09:00 AM
RE: Refinishing Bezel - by radiorich - 09-14-2022, 02:22 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration