Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1934/35 16RX chairside
#1

Question is does the control panel have a PHILCO decal on it? One examples in the gallery doesn't really have a good depiction of reality. And the other is original but it doesn't look like it had one. Can't imagine it not having a logo on the set somewhere.

I just got it back from Kirk which he reveneered the top and grainfilled it. I've got to put a few coats of sanding sealer just  so I can see if needs some toning. I looks wonderful before the ss. I'll post some pics after the ss.

https://philcoradio.com/gallery2/1935a/#Model_16RX

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
1934/35 16RX chairside - by Radioroslyn - 09-17-2022, 09:33 PM
RE: 1934/35 16RX chairside - by radiorich - 09-17-2022, 11:19 PM
RE: 1934/35 16RX chairside - by Ron Ramirez - 09-18-2022, 09:04 AM
RE: 1934/35 16RX chairside - by Radioroslyn - 09-18-2022, 11:53 AM
RE: 1934/35 16RX chairside - by Brad Winder - 09-19-2022, 11:07 AM
RE: 1934/35 16RX chairside - by Radioroslyn - 09-19-2022, 11:54 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>