09-22-2022, 09:24 AM
If the primary and secondary windings of the output transformer measure OK it shouldn't be too hard to remove it and apply heat shrink or liquid tape to the wires.
Philco 39-80B
« Next Oldest | Next Newest »
Messages In This Thread
Philco 39-80B - by cry42 - 09-18-2022, 04:36 PM
RE: Hello from Whitney Texas - by GarySP - 09-18-2022, 05:52 PM
RE: Hello from Whitney Texas - by cry42 - 09-18-2022, 06:01 PM
RE: Hello from Whitney Texas - by David - 09-18-2022, 07:43 PM
RE: Hello from Whitney Texas - by Radioroslyn - 09-18-2022, 07:44 PM
RE: Hello from Whitney Texas - by klondike98 - 09-18-2022, 10:14 PM
RE: Hello from Whitney Texas - by radiorich - 09-19-2022, 12:55 AM
RE: Hello from Whitney Texas - by cry42 - 09-19-2022, 09:53 AM
RE: Hello from Whitney Texas - by Eliot Ness - 09-19-2022, 12:33 PM
RE: Hello from Whitney Texas - by MrFixr55 - 09-19-2022, 08:25 PM
RE: Hello from Whitney Texas - by cry42 - 09-20-2022, 07:30 PM
RE: Hello from Whitney Texas - by Radioroslyn - 09-20-2022, 07:51 PM
RE: Hello from Whitney Texas - by cry42 - 09-20-2022, 08:31 PM
RE: Hello from Whitney Texas - by cry42 - 09-21-2022, 06:33 PM
RE: Hello from Whitney Texas - by David - 09-21-2022, 07:58 PM
RE: Hello from Whitney Texas - by MrFixr55 - 09-21-2022, 08:42 PM
RE: Philco 39-80B - by RodB - 09-22-2022, 09:24 AM
RE: Philco 39-80B - by cry42 - 09-24-2022, 05:39 PM
RE: Philco 39-80B - by RodB - 09-24-2022, 07:27 PM
RE: Philco 39-80B - by cry42 - 10-05-2022, 12:49 PM
RE: Philco 39-80B - by cry42 - 01-08-2023, 08:49 PM
Users browsing this thread: 1 Guest(s) |
|