1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Removing Tear Drop Type Door Pulls From a Philco 111 Hi-Boy
Radionut78
Junior Member
**
Posts: 15
Threads: 4
Joined: May 2010
#1

05-24-2011, 10:27 PM
I have a Philco 111 Hi-Boy cabinet with doors that needs restoring. Does anyone know how to remove the tear drop type door pulls from the doors of this cabinet?. Were the pulls installed with threaded screws inserted from the back of the door and then veneer installed over the rear of the door thereby hiding the heads of the screws? I'm almost certain the door pulls do not screw into the door panel but are held in place by regular machine screws. The problem is : How do I access the heads of these screws? Any help is welcome and most appreciated. Thanks .
Floyd
Find
« Next Oldest | Next Newest »


Messages In This Thread
Removing Tear Drop Type Door Pulls From a Philco 111 Hi-Boy - by Radionut78 - 05-24-2011, 10:27 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4899 online users. [Complete List]
» 2 Member(s) | 4897 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration