1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 51-930 resistor and capacitor questions
radiorich
Phorum Expert
*****
Posts: 1,597
Threads: 100
Joined: May 2008
City: Omak State, Province, Country: WA
#16

11-11-2022, 08:44 PM
Hello David,
that is what I figured the set is working beautifully!
I did do some mods to the set thou one is replacing the 35L6GT tube with a 50L6GT.
plus changing out that dropping resistor last thing I am going to do is connect in a 1/2 meg ohm pot and see what resistor will make this set sound the best to bad I could not hide a tweeter in it somewhere because the overall audio of this set is good for having a 4 by 6-inch woofer.
Maybe a 2 way 4 by 6 car speaker only if it had the right mounting nope that idea is out.


Sincerely Richard
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Philco 51-930 resistor and capacitor questions - by radiorich - 11-11-2022, 08:44 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration