1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
19v8 tube
radiorich
Phorum Expert
*****
Posts: 1,600
Threads: 101
Joined: May 2008
City: Omak State, Province, Country: WA
#3

02-19-2023, 02:08 PM
Hello Alan,
I see that this set used the hard to find tube the one cross is a 6V8 !
Because I did look up the tube specs for that tube plus the 19T8 .
good luck and maybe one the other members has a answer other than changing the radio design .

Sincerely Richard
Find
« Next Oldest | Next Newest »


Messages In This Thread
19v8 tube - by lasurveyor - 02-19-2023, 01:31 PM
RE: 19v8 tube - by gregb - 02-19-2023, 01:49 PM
RE: 19v8 tube - by radiorich - 02-19-2023, 02:08 PM
RE: 19v8 tube - by lasurveyor - 02-19-2023, 02:17 PM
RE: 19v8 tube - by klondike98 - 02-19-2023, 02:23 PM
RE: 19v8 tube - by lasurveyor - 03-02-2023, 11:10 AM
RE: 19v8 tube - by klondike98 - 03-02-2023, 07:34 PM
RE: 19v8 tube - by falcon123 - 03-12-2023, 02:29 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 3221 online users. [Complete List]
» 1 Member(s) | 3220 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration