Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

My Philco 38-7 Console Project - Electronic Questions
#19

I greatly appreciate all the time and effort you put in to my question!  Thank you!  It will take me a while to study my components now given your description, but I'm getting the feeling (which was my initial assessment) that I probably should persue modern speakers...which also has its challenges as I'd rather "harvest" them from someone's unwanted equipment instead of buying new.

I did purchase a $50 Pyle PCAU25P Amp so I could play around with Bluetooth (plus USB, Aux, and FM).  This (as everything "modern") is stereo so I've been pondering using two 6" mids even though it would "undo" the L/R stereo effect...or a 3.1 setup.  Right now I'm in the "analysis paralysis" stage trying to play "catch up" on a subject I've come to realize is a bit challenging for my aging brain!

My radio may have had some issue when I got it and my initial "investigation" may have made it worse, so it may be my "lessons learned" before touching my other two!   Icon_e_smile


Messages In This Thread
RE: My Philco 38-7 Console Project - Electronic Questions - by DavidK - 03-04-2023, 12:04 PM
RE: My Philco 38-7 Console Project - by DavidK - 03-02-2023, 12:48 AM
RE: My Philco 38-7 Console Project - by RodB - 03-02-2023, 11:11 AM
RE: My Philco 38-7 Console Project - by DavidK - 03-02-2023, 12:10 PM
RE: My Philco 38-7 Console Project - by RodB - 03-02-2023, 12:10 PM
RE: My Philco 38-7 Console Project - by DavidK - 03-02-2023, 01:08 PM
RE: My Philco 38-7 Console Project - by RodB - 03-02-2023, 03:08 PM
RE: My Philco 38-7 Console Project - by DavidK - 03-02-2023, 03:54 PM
462ron - by 462ron - 03-03-2023, 08:46 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6350 online users. [Complete List]
» 2 Member(s) | 6348 Guest(s)
AvatarAvatar

>