1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 212
RodB
Phorum Expert
*****
Posts: 990
Threads: 40
Joined: Feb 2015
City: Roseville, MN
#3

03-04-2023, 09:09 PM
Andy,

This happened to me when I mistakenly grounded the negative side of the filter caps to the chassis when they should have been connected to the hv center tap for floating B-.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 212 - by AVSorrell - 03-04-2023, 03:44 PM
RE: Philco 212 - by MrFixr55 - 03-04-2023, 04:02 PM
RE: Philco 212 - by RodB - 03-04-2023, 09:09 PM
RE: Philco 212 - by morzh - 03-04-2023, 10:33 PM
RE: Philco 212 - by MrFixr55 - 03-04-2023, 11:02 PM
RE: Philco 212 - by AVSorrell - 03-16-2023, 06:40 PM
RE: Philco 212 - by morzh - 03-16-2023, 08:09 PM
RE: Philco 212 - by MrFixr55 - 03-17-2023, 09:32 AM
RE: Philco 212 - by morzh - 03-17-2023, 05:56 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration