Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Coronado Oscillator problem
#2

Did you perform an IF alignment first? Is the output of your signal generator correct? Other then that maybe there is some fault in the oscillator tank circuit, but I would check the more obvious things first. Did you check R20, the 50,000 ohm resistor?


Messages In This Thread
Coronado Oscillator problem - by Tom45acp - 03-10-2023, 06:39 PM
RE: Coronado Oscillator problem - by Arran - 03-10-2023, 10:31 PM
RE: Coronado Oscillator problem - by MrFixr55 - 03-11-2023, 05:21 AM
RE: Coronado Oscillator problem - by Tom45acp - 03-11-2023, 10:15 AM
RE: Coronado Oscillator problem - by MrFixr55 - 03-12-2023, 02:40 AM
RE: Coronado Oscillator problem - by Tom45acp - 03-12-2023, 09:31 AM
RE: Coronado Oscillator problem - by RodB - 03-12-2023, 10:07 AM
RE: Coronado Oscillator problem - by MrFixr55 - 03-12-2023, 04:44 PM
RE: Coronado Oscillator problem - by Arran - 03-13-2023, 01:41 AM
RE: Coronado Oscillator problem - by Tom45acp - 03-13-2023, 07:24 AM
RE: Coronado Oscillator problem - by Tom45acp - 03-14-2023, 05:13 PM
RE: Coronado Oscillator problem - by Tom45acp - 03-21-2023, 07:02 AM



Users browsing this thread: 1 Guest(s)