1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Coronado Radio-Phonograph Model 43-7651 Series A
DavidK
Junior Member
**
Posts: 25
Threads: 5
Joined: Feb 2023
City: Cedar Rapids State, Province, Country: IA
#7

03-23-2023, 10:41 PM
Thanks again for the help!

Those two CAPS-to-Chassis puzzled me but I figured as long as I didn't hold the chassis in one hand and poke the Rectifier plate/tabs with a finger from my other hand then I was "safe"...or have I just been lucky that I wasn't grounded when holding the chassis?

I noticed the filaments were "glowing" and didn't know if that would cause problems so that's why I unsoldered that line.

Yes, I identified an O-ring via Amazon.com that should fit that Idler Wheel (rim); just haven't ordered it yet.  The weather has been favorable so I've been working on the cabinets lately.
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Coronado Radio-Phonograph Model 43-7651 Series A - by DavidK - 03-23-2023, 10:41 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM

[-]
Who's Online
There are currently 2616 online users. [Complete List]
» 2 Member(s) | 2614 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)