Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Antennas and Grounds and...
#1

blacks and reds, oh my.

First, sorry, searching here on "antenna" yields a bizillion results but I haven't yet cleared up my foggy understanding of antenna technology.

- Is there a primer anywhere here on the basics of antennas?
- Does any of the Philco lit tell the user how to connect Antenna, Ground, and Red & Black? And what are those even for? (I haven't found any info here yet).
- I see lots of "advice" in various places, with little explanation. Like ground the radio but don't use house ground. Huh? Why not?
   - Speaking of grounds... is it advisable to install a new grounded power cord, connecting the ground to chassis?
    - Speaking of new cords, if a new polarized plug is used, does it matter where the neutral and hot wires go?


Messages In This Thread
Antennas and Grounds and... - by patmat2350 - 04-16-2023, 07:38 PM
RE: Antennas and Grounds and... - by MrFixr55 - 04-17-2023, 10:36 AM
RE: Antennas and Grounds and... - by Chas - 04-17-2023, 10:44 AM
RE: Antennas and Grounds and... - by patmat2350 - 04-17-2023, 10:54 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 4532 online users. [Complete List]
» 1 Member(s) | 4531 Guest(s)
Avatar

>