Signal generator test leads

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Signal generator test leads

RodB
Phorum Expert

Posts: 986
Threads: 40
Joined: Feb 2015
City: Roseville, MN

05-12-2023, 09:15 AM

I use the loosely coupled approach. I feed the generator signal to a coil of wire through a .1mfd cap. Then move the coil close to the radio to get the correct signal strength. When I have to inject the signal I use a .05mfd cap with an alligator clip soldered to a lead.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Signal generator test leads - by patmat2350 - 05-11-2023, 04:10 PM

RE: Signal generator test leads - by klondike98 - 05-11-2023, 05:20 PM

RE: Signal generator test leads - by patmat2350 - 05-11-2023, 05:24 PM

RE: Signal generator test leads - by DaleHCook - 05-11-2023, 05:56 PM

RE: Signal generator test leads - by patmat2350 - 05-11-2023, 06:14 PM

462ron - by 462ron - 05-12-2023, 07:36 AM

RE: Signal generator test leads - by DaleHCook - 05-12-2023, 08:19 AM

RE: Signal generator test leads - by RodB - 05-12-2023, 09:15 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the 5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

Who's Online

There are currently 1364 online users. [Complete List]
» 1 Member(s) | 1363 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me