37-60 Started repair again
Posts: 79
Threads: 5
Joined: Jul 2021
City: RUBY
State, Province, Country: South Carolina
Haven't looked at the caps that I bought to go into the bakelite case yet (bought parts about 2 years ago). Hope they are very tiny or it could be real fun.
Reckon I could use flexible, insulated wire if I had to, if the caps fit like the originals. They were the size of AAA batteries.
Otherwise I'll have the empty case mounted with the caps on both sides at the bottom..
Bryan
Messages In This Thread
RE: 37-60 Started repair again - by Jordanbkc - 05-14-2023, 07:52 AM
Users browsing this thread: 13 Guest(s)
|
Recent Posts
|
Philco 60 Squealing
|
All correct shields must be in place, all tubes correct no subs of any kind.
Check any soldered, riveted ground conne...Chas — 01:24 PM |
Philco 60 Squealing
|
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM |
Philco 46-420 Code 121 Reception issues
|
Welcome Eric,
I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM |
Philco 46-420 Code 121 Reception issues
|
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM |
Philco 42-1008 conversion kit
|
Interesting. I haven't seen that before.klondike98 — 07:02 PM |
12' Philco
|
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM |
Shadow Meter Bulb
|
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM |
Shadow Meter Bulb
|
Ok. Thanks for the correction.RossH — 03:09 PM |
Model 28L
|
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM |
37-60 revision 6
|
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM |
Who's Online
|
There are currently 6303 online users. [Complete List] » 2 Member(s) | 6301 Guest(s)
|
|
|
|