Model 89 code 123

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Model 89 code 123

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

05-28-2023, 06:39 PM

Griff
You may want to check and see if your set receives stations all the way to the end of the dial 550 to 1500kc. If there is not enough turns on the osc coil feedback winding the osc will conkout before you get to the ends of the dial.

GL

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 89 code 123 - by Griff - 04-10-2023, 11:19 AM

RE: Model 89 code 123 - by MrFixr55 - 04-10-2023, 03:19 PM

RE: Model 89 code 123 - by Steve Davis - 04-10-2023, 08:48 PM

RE: Model 89 code 123 - by Griff - 04-11-2023, 06:29 PM

RE: Model 89 code 123 - by MrFixr55 - 04-11-2023, 10:56 PM

RE: Model 89 code 123 - by Griff - 05-28-2023, 02:32 PM

RE: Model 89 code 123 - by admin - 05-28-2023, 03:55 PM

RE: Model 89 code 123 - by Radioroslyn - 05-28-2023, 06:39 PM

Repaired Model 89 code 123 - by Griff - 05-28-2023, 02:28 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me