1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
bass does not work on 42-380
gennet2
Junior Member
**
Posts: 26
Threads: 8
Joined: Jun 2011
#7

06-21-2011, 06:18 AM
I looked at all the bakelite resisters and they all look fine except # 48 on schimatic which was up against anohter end of an exposed end if a wire and where it touched there was quite a bit of white powder on it. according to schematic this is 22o,000 ohms. Can I test this with a multimeter and how do I do it? Unit on, off.?
thanks
Bob
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
bass does not work on 42-380 - by gennet2 - 06-18-2011, 11:35 AM
Re: bass does not work on 42-380 - by gennet2 - 06-18-2011, 12:54 PM
Re: bass does not work on 42-380 - by exray - 06-18-2011, 04:42 PM
Re: bass does not work on 42-380 - by gennet2 - 06-19-2011, 05:36 AM
Re: bass does not work on 42-380 - by gennet2 - 06-21-2011, 05:56 AM
Re: bass does not work on 42-380 - by gennet2 - 06-21-2011, 06:18 AM
Re: bass does not work on 42-380 - by Raleigh - 06-24-2011, 12:31 AM



Users browsing this thread:
[-]
Recent Posts
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum, Martin! Open a new thread in Philco Electronic Restoration when you begin working on your 38-7. ...GarySP — 08:28 PM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum! :wave: Here's the schematic for that radio from our digital library: Something to do bef...klondike98 — 08:05 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration