Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

pilot lamp burn out
#7

Rich

I kinda doubt that this would change anything. Your rocker switch will do to a radio with its switch on the same as the radio's own switch would do. So if you decide to flip your external rocker switch quickly on after you have just powered the radio down, there is no difference in the process. And the pilot lamp might (I am not saying "will", but "might") just burn again.
And the bucking transformer itself will not prevent the lamp from burning, as the same inrush will happen. A discharged cap will draw lots of current from almost any voltage, and so difference of 5% to 10% won't matter.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.


Messages In This Thread
pilot lamp burn out - by lasurveyor - 06-11-2023, 12:11 PM
RE: pilot lamp burn out - by Paul Philco322 - 06-11-2023, 02:10 PM
RE: pilot lamp burn out - by morzh - 06-11-2023, 02:32 PM
RE: pilot lamp burn out - by Ron Ramirez - 06-11-2023, 02:56 PM
RE: pilot lamp burn out - by lasurveyor - 06-11-2023, 05:39 PM
RE: pilot lamp burn out - by radiorich - 06-11-2023, 09:31 PM
RE: pilot lamp burn out - by morzh - 06-11-2023, 09:43 PM
RE: pilot lamp burn out - by radiorich - 06-12-2023, 08:32 AM
RE: pilot lamp burn out - by morzh - 06-12-2023, 08:37 AM
RE: pilot lamp burn out - by Paul Philco322 - 06-12-2023, 10:30 AM
RE: pilot lamp burn out - by morzh - 06-12-2023, 11:11 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 5899 online users. [Complete List]
» 2 Member(s) | 5897 Guest(s)
AvatarAvatar

>