Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Howard 256 restoration
#14

Nice work kid! Paul B

Tubetalk1


Messages In This Thread
Howard 256 restoration - by klondike98 - 05-10-2023, 01:14 PM
RE: Howard 256 restoration - by radiorich - 05-10-2023, 07:33 PM
RE: Howard 256 restoration - by radiorich - 05-10-2023, 07:35 PM
RE: Howard 256 restoration - by klondike98 - 05-10-2023, 09:08 PM
RE: Howard 256 restoration - by radiorich - 05-10-2023, 10:07 PM
RE: Howard 256 restoration - by klondike98 - 05-12-2023, 08:39 PM
RE: Howard 256 restoration - by klondike98 - 05-22-2023, 07:24 PM
RE: Howard 256 restoration - by GarySP - 05-22-2023, 08:20 PM
RE: Howard 256 restoration - by DaleHCook - 05-22-2023, 09:27 PM
RE: Howard 256 restoration - by klondike98 - 05-22-2023, 09:57 PM
RE: Howard 256 restoration - by klondike98 - 06-12-2023, 07:38 PM
RE: Howard 256 restoration - by radiorich - 06-12-2023, 08:56 PM
RE: Howard 256 restoration - by radiorich - 06-12-2023, 08:59 PM
RE: Howard 256 restoration - by Paul Philco322 - 06-12-2023, 09:41 PM
462ron - by 462ron - 06-13-2023, 08:40 AM
RE: Howard 256 restoration - by morzh - 06-13-2023, 10:47 AM
RE: Howard 256 restoration - by klondike98 - 06-13-2023, 06:18 PM
RE: Howard 256 restoration - by GarySP - 06-14-2023, 08:55 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>