Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-255T Restoration
#6

You want a 6 inch electrodynamic Philco speaker with 1100 ohm field coil. This eliminates the 41-221 as a possibility, as its speaker is smaller than that.

The original part number is either 36-1483-2 or 36-1483-4, used in models 40-150, 40-155, 41-250 & 41-255.

Similar models with the same field coil specs: 36-1519-3, used in model 41-256 & 42-355.

Models 39-25 and 39-30 also use 6 inch speakers, but their field coils are rated at 2000 ohms.

Enough 40-150, 40-155, 41-250, and 41-255 models were made that you should not have too much trouble finding a suitable replacement.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
41-255t - by bridkarl - 06-15-2023, 06:40 PM
RE: 41-255T Restoration - by admin - 08-16-2023, 11:15 AM
RE: 41-255t - by klondike98 - 06-15-2023, 10:38 PM
RE: 41-255t - by radiorich - 06-16-2023, 09:26 AM
41-255T speaker substitutions - by bridkarl - 06-17-2023, 12:11 PM
RE: 41-255T speaker substitutions - by Ron Ramirez - 06-17-2023, 01:31 PM
RE: 41-255T speaker substitutions - by bridkarl - 07-02-2023, 10:43 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6317 online users. [Complete List]
» 2 Member(s) | 6315 Guest(s)
AvatarAvatar

>