Model 650 Tone Control Question
Posts: 65
Threads: 11
Joined: Nov 2021
City: Toronto
State, Province, Country: Ontario
http://www.nostalgiaair.org/Resources/824/M0013824.htm
I was looking at the tube voltages from the Nostalgiaair site for the Model 650 and I was under the impression that both 42 output tubes were to have the same voltages but this showed only one 42 output tube.
Should both 42 output tubes have the same plate and screen voltages?
Messages In This Thread
RE: Model 650 Tone Control Question - by Hamilton - 07-07-2023, 02:59 PM
Users browsing this thread: 6 Guest(s)
|
Recent Posts
|
Philco 60 Squealing
|
All correct shields must be in place, all tubes correct no subs of any kind.
Check any soldered, riveted ground conne...Chas — 01:24 PM |
Philco 60 Squealing
|
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM |
Philco 46-420 Code 121 Reception issues
|
Welcome Eric,
I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM |
Philco 46-420 Code 121 Reception issues
|
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM |
Philco 42-1008 conversion kit
|
Interesting. I haven't seen that before.klondike98 — 07:02 PM |
12' Philco
|
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM |
Shadow Meter Bulb
|
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM |
Shadow Meter Bulb
|
Ok. Thanks for the correction.RossH — 03:09 PM |
Model 28L
|
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM |
37-60 revision 6
|
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM |
Who's Online
|
There are currently 4209 online users. [Complete List] » 1 Member(s) | 4208 Guest(s)
|
|
|
|