1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Potentiometer question
Shaleradio
Junior Member
**
Posts: 46
Threads: 15
Joined: Nov 2017
City: Pittsburgh, PA
#1

07-26-2023, 02:09 PM
I have the ability to pick up a cannibalized 41-220.  This model was a plug in but no transformer.  There's not much left of it, but I would pick it up if I can throw in a Bluetooth and run new speakers (The speaker is also gone).  The question for the group is this.  My supply would be 12VDC.  Can I use the on/off switch (which is still there) to switch on and off my 12 volt power supply?  Not sure if the old one which was originally connected to AC could do this?
Thanks,
Mark
Find
« Next Oldest | Next Newest »


Messages In This Thread
Potentiometer question - by Shaleradio - 07-26-2023, 02:09 PM
RE: Potentiometer question - by klondike98 - 07-26-2023, 05:27 PM
RE: Potentiometer question - by Shaleradio - 07-26-2023, 05:50 PM
RE: Potentiometer question - by MrFixr55 - 07-26-2023, 06:12 PM
RE: Potentiometer question - by Shaleradio - 07-26-2023, 07:42 PM
RE: Potentiometer question - by klondike98 - 07-26-2023, 10:47 PM
RE: Potentiometer question - by Shaleradio - 07-27-2023, 08:42 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 6839 online users. [Complete List]
» 2 Member(s) | 6837 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration