551, 51, 51A clock radio

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

551, 51, 51A clock radio

Eric
Senior Member

Posts: 451
Threads: 85
Joined: Nov 2011
City: Cumming, GA

#10

07-30-2023, 02:39 PM

Ron,
I have a 10k pot and I believe it is Linear any way it acts but I'm not getting a lot of volume I have about 20-25 feet of antenna (enough?) and it plays a bit better with the ground attached (I have a separate ground stake). I did not get into the Capacitor Block 23 is this worth getting into? I have a Schematic that does give me the values for the 5 caps inside. They all seem to be located between the 2nd detector 24 and the output 47, 23A thru C.

Eric

Find

« Next Oldest | Next Newest »

Messages In This Thread

551, 51, 51A clock radio - by Eric - 07-27-2023, 08:48 AM

RE: 551, 51, 51A clock radio - by Radioroslyn - 07-27-2023, 02:57 PM

RE: 551, 51, 51A clock radio - by Eric - 07-28-2023, 08:44 AM

RE: 551, 51, 51A clock radio - by Ron Ramirez - 07-28-2023, 08:55 AM

RE: 551, 51, 51A clock radio - by Eric - 07-29-2023, 11:40 AM

RE: 551, 51, 51A clock radio - by Eric - 07-29-2023, 03:37 PM

RE: 551, 51, 51A clock radio - by Ron Ramirez - 07-29-2023, 03:48 PM

RE: 551, 51, 51A clock radio - by Eric - 07-29-2023, 05:49 PM

RE: 551, 51, 51A clock radio - by Ron Ramirez - 07-29-2023, 07:09 PM

RE: 551, 51, 51A clock radio - by Eric - 07-30-2023, 02:39 PM

RE: 551, 51, 51A clock radio - by Ron Ramirez - 07-30-2023, 02:49 PM

RE: 551, 51, 51A clock radio - by Eric - 08-01-2023, 08:12 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

Who's Online

There are currently 6309 online users. [Complete List]
» 2 Member(s) | 6307 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me