Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Tubes for the Philco 41-608
#5

The picture above has been fixed.

A reminder: You may find any prewar (and some postwar) Philco service information you may need, all for free, in the Philco Library:

https://philcoradio.com/library/

No membership fees. No restrictions. High resolution scans.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Tubes for the Philco 41-608 - by Guest - 12-22-2005, 02:39 PM
RE: Tubes for the Philco 41-608 - by Charlie2be - 08-15-2023, 12:53 AM
RE: Tubes for the Philco 41-608 - by Ron Ramirez - 08-15-2023, 08:46 AM
RE: Tubes for the Philco 41-608 - by Charlie2be - 08-15-2023, 10:07 AM
[No subject] - by Ron Ramirez - 12-22-2005, 08:21 PM
Thanks - by Guest - 12-23-2005, 01:43 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 6339 online users. [Complete List]
» 1 Member(s) | 6338 Guest(s)
Avatar

>