Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Capacitor lead length/mounting
#2

> Can you get caps with extra long leads

Not that I am aware of. If longer leads are needed when I replace caps, I just lengthen them. This is easy when I am restuffing old paper capacitor bodies - just add the long leads near each end of the capacitor body, then put the new cap inside the old paper shell, seal with hot glue, and no one will know the difference. Icon_thumbup

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Capacitor lead length/mounting - by bridkarl - 08-15-2023, 10:49 AM
RE: Capacitor lead length/mounting - by Ron Ramirez - 08-15-2023, 12:48 PM
RE: Capacitor lead length/mounting - by bridkarl - 08-15-2023, 01:13 PM
RE: Capacitor lead length/mounting - by morzh - 08-15-2023, 02:58 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

[-]
Who's Online
There are currently 4645 online users. [Complete List]
» 2 Member(s) | 4643 Guest(s)
AvatarAvatar

>