Philco model 43

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco model 43

codefox1
Silent Key

Posts: 2,128
Threads: 18
Joined: Oct 2008
City: Merrick, Long Island, NY

06-28-2011, 08:26 PM

Hope you figure it out, but in all honesty it probably wouldn't make a difference. As long as everything was peaked in approximately the same range, you schold be good to go. Didn't have no accurate frequency counters in the average shop way back when.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco model 43 - by vorlonwolf - 06-28-2011, 12:38 PM

Re: Philco model 43 - by Ron Ramirez - 06-28-2011, 04:33 PM

Re: Philco model 43 - by codefox1 - 06-28-2011, 08:26 PM

Re: Philco model 43 - by Chuck Schwark - 06-28-2011, 10:47 PM

Re: Philco model 43 - by Ron Ramirez - 06-28-2011, 11:18 PM

Re: Philco model 43 - by Arran - 06-28-2011, 11:59 PM

Re: Philco model 43 - by vorlonwolf - 06-30-2011, 08:40 AM

Re: Philco model 43 - by vorlonwolf - 07-14-2011, 11:33 AM

View a Printable Version

Users browsing this thread: 7 Guest(s)

Recent Posts
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM
Philco 60 Squealing
Your IF transformers are tuned to the resonant frequency they were designed for. When you observe the bell curve they di...RodB — 01:35 PM
identify very thin wire for replacement on 37-640
Thanks so much for your help! I really could not have gotten this far without the kindness of you and other members. T...georgetownjohn — 11:50 AM
Philco 38-7 Oscillation
Will do, thank you.tludka — 10:26 AM
Philco 38-7 Oscillation
As to your oscillation issue I would align the IF transformers. That may solve the problem. You also would want to check...Radioroslyn — 10:22 AM
Philco 38-7 Speaker
Thank you, I will check this out, I do have some shields I can place around the specific tubes. I searched the four que...tludka — 10:18 AM
Philco 38-7 Speaker
Also, check if any wires going to Grid Caps of the tubes that are supposed to be INSIDE of their respective shields (if ...morzh — 09:54 AM
Philco 38-7 Oscillation
Usually in this forum, when we discuss a radio, we do not multiply threads. You already have a thread on this. If you wa...morzh — 09:27 AM
identify very thin wire for replacement on 37-640
You can possibly use a heatshrink tubing. If you decide to replace the wire, anything gauge 24, 300V rated will do (it ...morzh — 09:25 AM
identify very thin wire for replacement on 37-640
Happy Thanksgiving, I have attche a photo of a very thin wire with black plastic-looking insulation(some of it has com...georgetownjohn — 09:14 AM

Who's Online

There are currently 3299 online users. [Complete List]
» 3 Member(s) | 3296 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me